Aug 2017 updated: Ucertify Cisco 300-365 practice exam 1-10

Act now and download your Cisco 300-365 test today! Do not waste time for the worthless Cisco 300-365 tutorials. Download Regenerate Cisco Deploying Cisco Wireless Enterprise Networks exam with real questions and answers and begin to learn Cisco 300-365 with a classic professional.

2017 NEW RECOMMEND

Free VCE & PDF File for Cisco 300-365 Real Exam
(Full Version!)

Pass on Your First TRY 100% Money Back Guarantee Realistic Practice Exam Questions

Free Instant Download NEW 300-365 Exam Dumps (PDF & VCE):
Available on:
http://www.certleader.com/300-365-dumps.html

Q1. Which show command will show whether a WLAN is locally or centrally switched on a Cisco Wireless Lan Controller? 

A. show ap config general Cisco_AP 

B. show wlan wlan_id 

C. show flexconnect summary 

D. show flexconnect group detail 

Answer:

Q2. A network engineer is experiencing issues enabling LAG on the WLC. Which four characteristics should be validated to ensure LAG configuration? (Choose four.) 

A. All ports participate in the LAG by default when LAG is enabled on the controller, y 

B. Dynamic interfaces and management are moved to port 1 

C. Primary and secondary ports are needed for each interface. 

D. Multiple untagged interfaces to the same port are not allowed. 

E. EtherChannel must be configured for mode "on" on the switch. 

F. Only one functional physical port is needed to continue to pass traffic. 

G. Multiple LAGs are permitted on the controller. 

H. The WLC does not need to be rebooted to enable the LAG configuration. 

Answer: A,D,E,F 

Q3. An engineer wants to configure Call Admission Control and ensure that AC is based on the capacity of the AP and considering the possible impact of other APs in the area. Which two configuration options are required? (Choose two.) 

A. StaticCAC 

B. Admission Control 

C. Load-Based AC 

D. Add Traffic Stream 

E. Reserved Roaming Bandwidth 

F. Expedited Bandwidth 

Answer: B,C 

Q4. A network engineer has installed 802.11ac access points with 80 MHz enabled; however, in the conference rooms, co-channel interference is being noticed. Under which tab in the RF profiles configuration can the engineer find the settings to tune the channel width for a group of APs? 

A. 802.11 

B. RRM 

C. High Density 

D. General 

Answer:

Q5. Which two methods to discover a controller does a MAP attempt when it boots up? (Choose two.) 

A. |f Ethernet and wireless are available, it attempts to discover only via Ethernet. 

B. if Ethernet is disconnected, it attempts to connect wirelessly using AWPP. 

C. if only wireless is available and it is configured as a MAP, it does not attempt to connect to a WLC. 

D. If Ethernet and wireless are available, it uses Ethernet first. If it cannot connect via Ethernet, then it chooses wireless. 

E. |f Ethernet is disconnected, it attempts to connect wirelessly using the configured DHCP option. 

Answer: A,B 

Q6. A client reports that video is not streaming. The administrator determines the client is connecting at a data rate of 12 Mbps and is trying to stream to a valid multicast address on the network. What three items should the administrator check next to troubleshoot the issue? (Choose three) 

A. IGMP snooping is turned off because the client cannot request to join a group, only access points can. 

B. Video-stream for the multicast video is configured in the controller. 

C. WLAN has been set for a QoS value of Platinum. 

D. WLAN has been configured to allow multicast-direct to work correctly and multicast-direct has been enabled globally. 

E. WLAN has been set for a QoS value of Gold. 

F. RTSP is used to stream the video due to wireless multicast not using acknowledgements. 

Answer: B,D,E 

Q7. An engineer wants to configure WebEx to adjust the precedence and override the QoS profile on the WLAN. Which configuration is needed to complete this task? 

A. Change the AVC application WebEx-app-sharing to mark 

B. Create an ACL for WebEx. 

C. Change the WLAN reserved bandwidth for WebEx. 

D. Create an AVC profile for WebEx marked with a lower DSCP value 

Answer:

Q8. A network engineer must ensure that corporate wireless users have a better experience than guest wireless users. Which two configurations fulfil requirement? (Choose two.) 

A. Override per-SSID bandwidth contracts on the corporate WLAN to reserve bandwidth. 

B. Modify the corporate WLAN to the Platinum QoS policy. 

C. Enable 802.1ptag on the Gold QoS pofccyto honor prioritized traffic. 

D. Adjust the guest WLAN radio policy to 80211 b/g only. 

E. Change the guest WLAN to the Bronze QoS policy. 

Answer: B,E 

Q9. A wireless engineer at a convention center has been asked to provision an SSID that can accommodate 4,000 users during a conference. Which interface group configuration should be used? 

A. One interface with /20 mask 

B. Two interfaces with /21 mask 

C. Four interfaces with /22 mask 

D. Eight interfaces with /23 mask 

Answer:

Q10. A network engineer is viewing the QBSS information in a packet sniff. Which two QBSS characteristics are crucial for successful troubleshooting? (Choose two.) 

A. When only WMM is enabled, information element number 1 QBSS Load information element is sent out in the beacons and probe responses. 

B. When only WMM is enabled, information element number 3 QBSS Load information element is sent out in the beacons and probe responses. 

C. When the client CAC limit is supported, information element number 2 is sent out in the beacons and probe responses on the bg radios. 

D. When the client CAC limit is supported, information element number 1 is sent out in the beacons and probe responses on the bg radios. 

E. When only WMM is enabled, information element number 2 QBSS Load information element is sent out in the beacons and probe responses. 

Answer: D,E 

Certleader Dumps
Certleader is a company specialized on providing high quality IT exam materials and fully committed to assist our respected clients crack any IT certification tests on their 1st efforts.