Examples of ccna wireless 200 355 dumps

Proper study guides for Far out Cisco Implementing Cisco Wireless Network Fundamentals certified begins with Cisco 200 355 vce preparation products which designed to deliver the Accurate ccna wireless 200 355 dumps questions by making you pass the 200 355 vce test at your first time. Try the free 200 355 wifund demo right now.

2017 NEW RECOMMEND

Free VCE & PDF File for Cisco 200-355 Real Exam
(Full Version!)

Pass on Your First TRY 100% Money Back Guarantee Realistic Practice Exam Questions

Free Instant Download NEW 200-355 Exam Dumps (PDF & VCE):
Available on:
http://www.certleader.com/200-355-dumps.html

Q161. You need to set up an ad hoc connection to another client in a conference room to exchange files using Windows 7. Which two items do you need to create this connection? (Choose two.) 

A. SSID name 

B. RF channel 

C. 802.1X/EAP credentials 

D. pre-shared key 

E. Telnet 

F. IBSS name 

G. SSH 

Answer: D,F 

Q162. An engineer is conducting an active survey for indoor coverage in a warehouse. The warehouse has long aisles with racks that extend to the ceiling. Which antenna type has a radiation pattern that is suited to provide coverage in each aisle? 

A. Yagi 

B. patch 

C. omnidirectional 

D. dipole 

Answer:

Q163. Refer to the exhibit. 

How do improperly set Telnet/SSH parameters effect the configuration of a controller with Cisco WCS? 

A. The CLI and GUI management of the controller both fail because Cisco WCS checks these credentials before opening a session. 

B. The Telnet/SSH username must have sufficient privileges to execute commands in CLI templates. 

C. The GUI management of the controller fails because the Cisco WCS uses the Telnet/SSH parameters to login to the controller. 

D. The controller remains configured in the Cisco WCS, but no management is possible through GUI from other client browsers. 

Answer:

Q164. Refer to the exhibit. An engineer is configuring a SSID to utilize the management interface on the WLC. The management interface is configured with an untagged VLAN in the wireless controller interface settings. The controller is connected to a neighboring switch via the interface shown in the diagram. 

Which VLAN will traffic coming from the newly created SSID use to traverse the wired network? 

A. 1 

B. 20 

C. 44 

D. 50 

Answer:

Q165. An engineer recently removed a WLC from a WCS, but the APs associated to the WLC are still showing on the WCS. What is a reason for this? 

A. The associated APs must be removed manually. 

B. The APs must be removed from the WCS map. 

C. The hold-down timer must expire before the APs will be removed. 

D. The APs must be audited. 

Answer:

Q166. An installation uses a 21dBi parabolic dish. It is connected to the 802.11n radio via low loss antenna coax rated at 4dB loss/100 feet. After testing, it has been determined that 2mW of power will be lost in the cable. An EIRP producing 200mW is desired. What should the transmit power be set to? 

A. 8mW 

B. 3dBm 

C. 3.16mW 

D. 5mW 

Answer:

Q167. Which action secures the SNMPv2C protocol in a Cisco WLC? 

A. configure new communities and disable default communities 

B. use digital certificates to authenticate and encrypt transmissions 

C. enable password or transfer encryption 

D. set a username and difficult-to-guess password 

Answer:

Q168. What must be done for Cisco WLC and Cisco WCS to communicate? 

A. The IP address and subnet mask of the Cisco WLC must be configured in the Cisco WCS. 

B. The IP address and subnet mask of the Cisco WCS must be configured in the Cisco WLC. 

C. The identity certificate of the Cisco WLC must be added to the Cisco WCS. 

D. The Cisco WLC and Cisco WCS must exchange identity certificates. 

Answer:

Q169. An engineer is adding a controller to a WCS. What three categories of parameters are needed? (Choose three.) 

A. IP parameters 

B. SNMP Parameters 

C. Mobility Parameters 

D. Telnet/SSH Parameters 

E. TFTP Parameters 

F. RADIUS Parameters 

Answer: A,B,D 

Q170. When using DHCP option 43, the discovery option supports vendor specific identifiers in order to obtain what IP address? 

A. core router's gateway 

B. closest distribution switch 

C. local WLAN controller 

D. local Radius Server 

Answer:

Certleader Dumps
Certleader is a company specialized on providing high quality IT exam materials and fully committed to assist our respected clients crack any IT certification tests on their 1st efforts.