Finding Update 200-125 class

It is impossible to pass Cisco 200-125 exam without any help in the short term. Come to {brand} soon and find the most advanced, correct and guaranteed Cisco 200-125 practice questions. You will get a surprising result by our Most up-to-date CCNA Cisco Certified Network Associate CCNA (v3.0) practice guides.

2016 Sep 200-125 Study Guide Questions:

Q191. – (Topic 2) 

Which are valid modes for a switch port used as a VLAN trunk? (Choose three.) 

A. transparent 

B. auto 

C. on 

D. desirable 

E. blocking 

F. forwarding 

Answer: B,C,D 

Q192. – (Topic 9) 

Which three commands can you use to set a router boot image? (Choose three.) 

A. Router(config)# boot system flash c4500-p-mz.121-20.bin 

B. Router(config)# boot system tftp c7300-js-mz.122-33.SB8a.bin 

C. Router(config)#boot system rom c7301-advipservicesk9-mz.124-24.T4.bin 

D. Router> boot flash:c180x-adventerprisek9-mz-124-6T.bin 

E. Router(config)#boot flash:c180x-adventerprisek9-mz-124-6T.bin 

F. Router(config)#boot bootldr bootflash:c4500-jk9s-mz.122-23f.bin 

Answer: A,B,C 

Q193. – (Topic 9) 

Which two statements about IPv6 router advertisement messages are true? (Choose two.) 

A. They use ICMPv6 type 134. 

B. The advertised prefix length must be 64 bits. 

C. The advertised prefix length must be 48 bits. 

D. They are sourced from the configured IPv6 interface address. 

E. Their destination is always the link-local address of the neighboring node. 

Answer: A,B 

200-125  free question

Up to the immediate present 200-125 exam engine:

Q194. – (Topic 2) 

Refer to the topology shown in the exhibit. 

Which ports will be STP designated ports if all the links are operating at the same bandwidth? (Choose three.) 

A. Switch A – Fa0/0 

B. Switch A – Fa0/1 

C. Switch B – Fa0/0 

D. Switch B – Fa0/1 

E. Switch C – Fa0/0 

F. Switch C – Fa0/1 

Answer: B,C,D 

Q195. – (Topic 2) 

Based on the network shown in the graphic 

Which option contains both the potential networking problem and the protocol or setting that should be used to prevent the problem? 

A. routing loops, hold down timers 

B. switching loops, split horizon 

C. routing loops, split horizon 

D. switching loops, VTP 

E. routing loops, STP 

F. switching loops, STP 

Answer: F 

Q196. – (Topic 3) 

Refer to the exhibit. 

All of the routers in the network are configured with the ip subnet-zero command. Which network addresses should be used for Link A and Network A? (Choose two.) 

A. Network A – 172.16.3.48/26 

B. Network A – 172.16.3.128/25 

C. Network A – 172.16.3.192/26 

D. Link A – 172.16.3.0/30 

E. Link A – 172.16.3.40/30 

F. Link A – 172.16.3.112/30 

Answer: B,D 

certleader.com

Verified 200-125 rapidshare:

Q197. – (Topic 7) 

Which will fix the issue and allow ONLY ping to work while keeping telnet disabled? 

A. Correctly assign an IP address to interface fa0/1. 

B. Change the ip access-group command on fa0/0 from "in* to "out. 

C. Remove access-group 106 in from interface fa0/0 and add access-group 115 in. 

D. Remove access-group 102 out from interface s0/0/0 and add access-group 114 in 

E. Remove access-group 106 in from interface fa0/0 and add access-group 104 in. 

Answer: E 

Q198. – (Topic 9) 

Which type of address is the public IP address of a NAT device? 

A. outside global 

B. outside local 

C. inside global 

D. inside local 

E. outside public 

F. inside public 

Answer: C 

Q199. – (Topic 2) 

Refer to the exhibit. 

A network administrator is configuring an EtherChannel between SW1 and SW2. The SW1 configuration is shown. What is the correct configuration for SW2? 

A. interface FastEthernet 0/1 

channel-group 1 mode active 

switchport trunk encapsulation dot1q 

switchport mode trunk 

interface FastEthernet 0/2 

channel-group 1 mode active 

switchport trunk encapsulation dot1q 

switchport mode trunk 

B. interface FastEthernet 0/1 

channel-group 2 mode auto 

switchport trunk encapsulation dot1q 

switchport mode trunk 

interface FastEthernet 0/2 

channel-group 2 mode auto 

switchport trunk encapsulation dot1q 

switchport mode trunk 

C. interface FastEthernet 0/1 

channel-group 1 mode desirable 

switchport trunk encapsulation dot1q 

switchport mode trunk 

interface FastEthernet 0/2 

channel-group 1 mode desirable 

switchport trunk encapsulation dot1q 

switchport mode trunk 

D. interface FastEthernet 0/1 

channel-group 1 mode passive 

switchport trunk encapsulation dot1q 

switchport mode trunk 

interface FastEthernet 0/2 

channel-group 1 mode passive 

switchport trunk encapsulation dot1q 

switchport mode trunk 

Answer: C 

Q200. – (Topic 4) 

Which two are advantages of static routing when compared to dynamic routing? (Choose two.) 

A. Configuration complexity decreases as network size increases. 

B. Security increases because only the network administrator may change the routing table. 

C. Route summarization is computed automatically by the router. 

D. Routing tables adapt automatically to topology changes. 

E. An efficient algorithm is used to build routing tables, using automatic updates. 

F. Routing updates are automatically sent to neighbors. 

G. Routing traffic load is reduced when used in stub network links. 

Answer: B,G 

About 200-125 Information: 200-125 Dumps

Certleader Dumps
Certleader is a company specialized on providing high quality IT exam materials and fully committed to assist our respected clients crack any IT certification tests on their 1st efforts.