Proper study guides for Refresh Cisco CCIE SP Written v4.0 certified begins with Cisco 400-201 preparation products which designed to deliver the Validated 400-201 questions by making you pass the 400-201 test at your first time. Try the free 400-201 demo right now.
2017 NEW RECOMMEND
Free VCE & PDF File for Cisco 400-201 Real Exam
Pass on Your First TRY 100% Money Back Guarantee Realistic Practice Exam Questions
Q71. Refer to the exhibit. OSPFv3 is already running, and R1 has added a new subnet (loopback 11). What is the reason code on R4 when executing the command show ipv6 ospf statistics?
A. P (partial)
B. N (network)
C. R (router)
D. L (link)
Q72. In a frame, the MPLS label is imposed where?
A. Before the layer 2 header
B. Within the Layer 3 header
C. After the Layer3 header and before Layer2 header
D. After the Layer2 header and before Layer3 header
Q73. Customers connecting to a Service Provider for Internet access are intending to implement redundant peering. The design requirements call for preferring a primary link for both ingress and egress traffic. Secondary links should be used only during primary outages. What two BGP deployment options will accomplish this design goal? (Choose two.)
A. On the router handling the secondary link, advertise routes with a MED value of 0.
B. On the router handling the primary link, set the weight for all incoming routes to be a value of 0.
C. On the router handling the secondary link, advertise all routes with a longer AS-PATH value.
D. On the router handling the primary link, advertise all routes with a longer AS-PATH value.
E. On the router handling the secondary link, set the local preference for all incoming routes to be a value of 0.
Q74. Refer to the exhibit. An SP core is running MPLS with OSPF as the IGP used for Loopback propagation. LDP Synchronization is enabled per the given configuration. What will the traffic flow behavior be after a temporary outage event on PE1 Eth0/0?
A. Permanently through PE1 -> P2 -> PE4 due to lowest path metric.
B. Initially through PE1 -> P1 -> PE4, then a few seconds later, it will be over PE1 -> P2 -> PE4.
C. Permanently through PE1 -> P1 -> PE4 due to lowest path metric.
D. Initially through PE1 -> P2 -> PE4, then a few seconds later, it will be over PE1 -> P1 -> PE4
Q75. Two switches are connected back-to-back using two Gigabit Ethernet interfaces. These two interfaces are assigned to a port channel in VLAN trunk mode. Which configuration sequence allows the addition of a new VLAN in this link?
A. Add the VLAN to the port channel only, and remove it from the individual links.
B. Add the VLAN to both the port channel and individual links.
C. Add the VLW to the port channel only, and it will be reflected on the individual links.
D. Add the VLAN to the individual links, and it will be reflected on the port channel.
Q76. A network engineer is responsible for implementing a solution with Cisco IOS XR Software that insures continuous forwarding during a control plane failure. Which two technologies should the engineer consider? (Choose two.)
A. TE FRR
B. IP FRR
C. graceful restart
Q77. Refer to the exhibit. Which statement is true?
A. This is an inter autonomous unicast route.
B. The BGP MED value is 26.
C. This is an mVPN route.
D. The route target value is 10.1.100.2:3.
E. There is a route reflector in this network.
F. The route did not import this route into the VRF one.
Q78. A Service Provider is offering VoIP services and a service level agreement to customers. Which configuration provides validation to customers that the service level agreement has been honored?
A. ip sla 999 udp-jitter 220.127.116.11 1000 codec g729a tos 160 ip sla schedule 999 life forever start-time now
B. ip sla 999 icmp-jitter 18.104.22.168 tos 160 ip sla schedule 999 life forever start-time now
C. ip sla 999 icmp-jitter 22.214.171.124 tag VoIP-SLA ip sla schedule 999 life forever start-time now
D. ip sla 999 udp-jitter 126.96.36.199 1000 codec g729a tag VoIP-SLA
ip sla schedule 999 life forever start-time now
Q79. What is the main advantage of H-VPLS over VPLS?
A. H-VPLS provides redundancy.
B. H-VPLS provides security.
C. H-VPLS improves the scalability.
D. H-VPLS allows a broader use of protocols.
Q80. Which MPLS technology will achieve LAN extensions over the service provider backbone?