Amazing ccna data center dcict 640 916 official cert guide secrets

Breathing of ccna data center 640 916 pdf free exam questions materials and answers for Cisco certification for IT specialist, Real Success Guaranteed with Updated ccna data center 640 916 pdf pdf dumps vce Materials. 100% PASS Introducing Cisco Data Center Technologies – DCICT exam Today!


Free VCE & PDF File for Cisco 640-916 Real Exam
(Full Version!)

Pass on Your First TRY 100% Money Back Guarantee Realistic Practice Exam Questions

Free Instant Download NEW 640-916 Exam Dumps (PDF & VCE):
Available on:

Q51. A customer wants to deploy single-hop FCoE in the data center using Cisco Nexus 5500 switches. Which three configuration steps are needed for this deployment? (Choose three.) 

A. Enable the FCoE feature on the Cisco Nexus 5500. 

B. Configure FCoE VSAN to VLAN mapping. 

C. Configure the virtual Fibre Channel interface. 

D. Configure FCoE-NPV mode on the Cisco Nexus 5500. 

E. Configure the storage VDC for FCoE. 

F. Enable NPV on the Cisco Nexus 5500. 

Answer: A,B,C 

Q52. Where does the data plane operate on a Cisco Nexus 7000 Series Switch? 

A. unified crossbar fabric 

B. unified port controller 

C. supervisor module 

D. Policy Feature Card 

E. Connectivity Management Processor 


Q53. Which is a key characteristic of virtual device contexts? 

A. allowing logical switches to be aggregated into a single physical switch 

B. allowing logical switches to be aggregated into multiple physical switches 

C. allowing physical switches to be partitioned to a single virtual switch 

D. allowing physical switches to be partitioned to multiple virtual switches 


Q54. Which IEEE protocol provides bandwidth management and priority selection? 

A. Priority-based Flow Control (802.1Qbb) 

B. Enhanced Transmission Selection (802.1Qaz) 

C. Bandwidth Demand Circuit (802.1Qax) 

D. Quantized Congestion Control (802.1Qau) 

E. Data Center Bridging Exchange (802.1Qab) 


Q55. Which two installation models are supported by Cisco virtual interfaces? (Choose two.) 

A. pass-through switching 

B. hypervisor controlled 

C. native switching 

D. channeled uplink 

E. store-and-forward switching 

Answer: A,B 

Q56. Which command issued on the Cisco Nexus 1000V VSM validates the connection to the VMware vCenter server? 

A. N1000v-VSM# show vmware-vim 

B. N1000v-VSM# show connections vmware 

C. N1000v-VSM# show svs connections 

D. N1000v-VSM# show vcenter status 


Q57. For which two reasons should customers deploy FCoE beyond the access layer? (Choose two.) 

A. higher throughput compared to traditional Fibre Channel 

B. better security than traditional Fibre Channel 

C. device consolidation 

D. FCoE cannot be deployed beyond the access layer. 

Answer: A,C 

Q58. What two options are performed during initial setup of a UCS Manager? (Choose two.) 

A. Configuring Nodes 

B. Configuring Servers 

C. Configure Routing 

D. Configure Equipment Policy 

E. Configure Ports 

Answer: D,E 

Q59. Which option describes what VNTags are used for? 

A. to separate broadcast domains 

B. to identify and separate virtual interfaces 

C. to prioritize FCoE traffic 

D. to extend a Layer 2 domain across a Layer 3 boundary 


Q60. Which three items are needed to perform the initial setup for a Cisco Data Center device? (Choose three.) 

A. IP address and network mask 

B. FTP password 

C. Active Directory password 

D. console cable 

E. device software licenses 

F. admin password to assign to the device 

G. SFP+ cables 

Answer: A,D,F